A Draft of our new online Launcher User Manual is available now. Please send us any comments. This document is stored in our new web document system and can be easily updated and maintained.
Category Archives: Antenna Launching
Honking Launcher
Tonite we were testing a launcher we are building for a customer. It had the recently noted ‘honking launcher’ problem. We tried a few of the new air dusters and several of them had the problem.
Recommendation to Kit Builders – Don’t cement the trigger to brass elbow and brass elbow to valve top joints. It is much easier to troubleshoot and repair without cement. If you have a bad trigger contact us.
We are working on a measurement system to test the triggers before they are shipped. This may create an additional delay in shipping some launchers, but we want them to work properly.
If your launcher won’t make at least 100 feet of elevation with 50 psi it may have this problem. Contact us.
Honking Launcher
If your pneumatic launcher makes a ‘honking’ type noise when you trigger it, this is an indication of low trigger airflow. It is also a sure sign of an underperforming launcher.
The Harbor Freight air dusters we use for triggers sometimes exhibit this problem when the valve is overtightened into the frame. Loosen the nut around the pin that the trigger pushes on about 1 turn. There is an O ring seal there, so this should not cause it to leak. The honking should cease and the performance increase.
In the past this happened very rarely (only once that we are aware of), but with the new batches of parts it has happened at least twice recently.
The other problem we have seen that causes inadequate trigger flow is the installation of the outlet jet on the air duster. This outlet jet should not be installed to allow the best trigger flow.